Added new telstick windows drivers

Former-commit-id: 797b455c0a2b358e691a198017acea4eb5c02f73

arduino/lib/BH1750/Examples/BH1750_Led/BH1750_Led.ino

@@ -0,0 +1,74 @@
+/*
+  This is a simple code to test BH1750FVI Light senosr
+  communicate using I2C Protocol 
+  this library enable 2 slave device address
+  Main address  0x23 
+  secondary address 0x5C 
+  connect this sensor as following :
+  VCC >>> 3.3V
+  SDA >>> A4 
+  SCL >>> A5
+  addr >> A3
+  Gnd >>>Gnd
+
+  Written By : Mohannad Rawashdeh
+  
+ */
+ 
+ // First define the library :
+ #include <BH1750FVI.h> // Sensor Library
+ #include <Wire.h> // I2C Library
+ 
+ uint16_t Light_Intensity=0;
+ // Call the function 
+ #define LedPin 9 // led connecting to pin D9
+ BH1750FVI LightSensor;
+
+ int SensorValue =0;
+void setup() {
+  // put your setup code here, to run once:
+  Serial.begin(9600);
+ //  call begin Function so turn the sensor On .
+  LightSensor.begin();
+ /*
+ Set the address for this sensor 
+ you can use 2 different address
+ Device_Address_H "0x5C"
+ Device_Address_L "0x23"
+ you must connect Addr pin to A3 .
+ */
+  LightSensor.SetAddress(Device_Address_H); //Address 0x5C
+ // To adjust the slave on other address , uncomment this line
+ // lightMeter.SetAddress(Device_Address_L); //Address 0x5C
+ //-----------------------------------------------
+   /*
+   set the Working Mode for this sensor 
+   Select the following Mode:
+    Continuous_H_resolution_Mode
+    Continuous_H_resolution_Mode2
+    Continuous_L_resolution_Mode
+    OneTime_H_resolution_Mode
+    OneTime_H_resolution_Mode2
+    OneTime_L_resolution_Mode
+    
+    The data sheet recommanded To use Continuous_H_resolution_Mode
+  */
+  LightSensor.SetMode(Continuous_H_resolution_Mode);
+  pinMode(9,OUTPUT) // Connect LED With 100ohm resistor
+  // to pin D9
+  
+  
+}
+
+void loop() {
+  // put your main code here, to run repeatedly: 
+  // call GetLightIntensity() Function , so the sensor read
+  //the Intensity Value and send it 
+  Light_Intensity=LightSensor.GetLightIntensity();
+  delay(50);
+ 
+  SensorValue=map(Light_Intensity,0,2000,255,0);
+  SensorValue=constrain(SensorValue,255,0);
+  digitalWrite(LedPin,SensorValue);
+  // ready to another reading . 
+}