If not zero, automatically switch off/close blind after a user defined time If not zero, automatically switch off/close blind after a user defined time Defines if the dimmer shall ignore start level in StartLevelChange command despite it is specified or not. Time to dim on button presses and Set command (if it has no duration specified). If not 0, dimming will be done smoothly to preserve bulb life. Time to dim on button holds and StartLevel Change command (if it has no duration specified). Defines if the dimmer shall set maximum light level on On command. By default on On command dimmer restores last level. This parameter allows to configure to set maximum level on second On command (if already On) or to always switch on to maximum level. Time to dim on double click Off button for Baby- Dim function. This function works only if the load is operated by single press and hold button action. If enabled, the device will wait for a click timeout to see if the second click would be pressed. This will introduce a small delay for single click commands, unprotected. Target level on which to stop while executing Baby Dimming. Can be 0 to completely switch off the light. Typical time used to differentiate click, hold, double and triple clicks. If disabled, the local operations by buttons will not switch the load, but only send commands to On/Off association group. In this mode buttons are not linked with the switch anymore. They can be used separately: buttons to control remote device, switch will operate by RF commands only. Defines which command should be sent on button single press or hold. Basic commands are sent to Association group. Switch All commands are sent broadcast. Defines which command should be sent on button double press or press-hold. Basic commands are sent to Association group. Switch All commands are sent broadcast. If not disabled, the device will wait for a click timeout to see if the second click would be pressed. This will introduce a small delay for single click commands.