/*

This is a library for the BH1750FVI Digital Light Sensor
breakout board.

The board uses I2C for communication. 2 pins are required to
interface to the device.

Datasheet:
http://rohmfs.rohm.com/en/products/databook/datasheet/ic/sensor/light/bh1750fvi-e.pdf

based on Christopher Laws, March, 2013 code.

*/
#ifndef HARDWAREBH1750_H
#define HARDWAREBH1750_H

#include <Wire.h>
#include "HalInterfaces.h"


#define BH1750_DEBUG 0

#define BH1750_I2CADDR 0x23

// No active state
#define BH1750_POWER_DOWN 0x00

// Waiting for measurement command
#define BH1750_POWER_ON 0x01

// Reset data register value - not accepted in POWER_DOWN mode
#define BH1750_RESET 0x07

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
#define BH1750_CONTINUOUS_HIGH_RES_MODE  0x10

// Start measurement at 0.5lx resolution. Measurement time is approx 120ms.
#define BH1750_CONTINUOUS_HIGH_RES_MODE_2  0x11

// Start measurement at 4lx resolution. Measurement time is approx 16ms.
#define BH1750_CONTINUOUS_LOW_RES_MODE  0x13

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_HIGH_RES_MODE  0x20

// Start measurement at 0.5lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_HIGH_RES_MODE_2  0x21

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_LOW_RES_MODE  0x23


class HardwareBH1750 : public HardwarePowerConsumption, public HardwareLight{
public:
    virtual void setup();
    virtual unsigned int getLuminosity();
    virtual unsigned int getConsumption();
    virtual void reset();

    void configure(uint8_t mode);
private:
    unsigned int pulses;
    void write8(uint8_t data);

};

#endif // HARDWAREBH1750_H